Synthesized, optical properties and biological activity of copper oxide nanoparticles prepared by various parameters of laser ablation technique in DDW
Keywords:
Laser ablation, Copper oxide NPs, Optical characteristics, Morphology of CuO, Antibacterial activity.Abstract
In this paper, copper oxide nanoparticles were prepared through Q-switched Nd:YAG laser ablation. The ablation process was carried out on a copper pellet that was submerged in double-distilled water. The ablation was performed at two different energy levels, specifically 200 ml and 400 ml, and with varying numbers of pulses ranging from 100 to 500 by step 100. The morphological and optical characteristics of nanoparticles were ascertained through the utilization of a UV-Vis spectrophotometer, transmission electron microscopy (TEM) and atomic force microscopy (AFM). As the laser pulses were increased, surface plasmon resonance peaks were observed in the absorption spectra at 217 nm. Additionally, there was a slight decrease in the optical band gap. The results of the UV-vis and TEM analyses indicated the presence of CuO nanoparticles that were almost spherical in shape. The average diameter of these nanoparticles was found to be about 46 nm and 52 nm when the energies used were 200 mJ and 400 mJ, respectively. It is noteworthy that the particle size of CuONPs was increased by increasing the laser energy of ablation .Moreover, the findings of our investigation indicate that the inhibitory effect against both Bacillus cereus and Pseudomonas aeruginosa, respectively, was enhanced by CuONPs at 200 mJ in comparison with 400 mJ with the same number of pulses.
Downloads
References
Al-Douri Y, Al-Samarai RA, Abdulateef SA, Odeh AA, Badi N, Voon CH. 2019. Nanosecond pulsed laser ablation to synthesize GaO colloidal nanoparticles: optical and
structural properties. Optik (Stuttg).;178:337-42.
Allaker, R.P., 2010. The use of nanoparticles to control oral
biofilm formation. Journal of dental research, 89(11),
pp.1175-1186.
Arakelyan, S. M., Veiko, V. P., Kutrovskaya, S. V., et al.,2016.
Reliable and well-controlled synthesis of noble metal
nanoparticles by continuous wave laser ablation in
different liquids for deposition of thin films with
variable optical properties. J Nanopart Res.18, 155.
https://doi.org/10.1007/s11051-016-3468-0
Azam, A., Ahmed, A.S., Oves, M.( Khan, M.S. and Memic, A.,
Size-dependent antimicrobial properties of CuO
nanoparticles against Gram-positive and-negative
bacterial strains. International journal of nanomedicine,
pp.3527-3535
Azadi, H., Aghdam, H.D., Malekfar, R. and Bellah, S.M., 2019.
Effects of energy and hydrogen peroxide concentration
on structural and optical properties of CuO nanosheets
prepared by pulsed laser ablation. Results in Physics, 15,
p.102610
Bhardwaj, A.K., Kumar, V., Pandey, V., Naraian, R. and
Gopal, R., 2019. Bacterial killing efficacy of synthesized
rod shaped cuprous oxide nanoparticles using laser
ablation technique. SN Applied Sciences,1, pp.1-8.
Carlin, F., M. Fricker, A. Pielaat, S. Heisterkamp, R. Shaheen,
M. S. Salonen, B. Svensson, C. Nguyen-The, and M.
EhlingSchulz. 2006. Emetic toxin-producing strains of
Bacillus cereus show distinct characteristics within the
Bacillus cereus group. Int. J. Food Microbiol. 109:132-138
Dufrenne, J., A. Tatini, and S. Notermans. 1994. Stability of
spores of Bacillus cereus stored on silicagel. Int. J. Food
Microbiol. 23:111-116.
El Zowalaty M.E, Al Thani A.A, Webster TJ, El Zowalaty A.E,
Schweizer H.P, Nasrallah G.K, Marei H.E, Ashour H.M. .
Pseudomonas aeruginosa: arsenal of resistance
mechanisms, decades of changing resistance profiles,
and future antimicrobial therapies. Future
Microbiol.10(10):1683-706.
http://dx.doi.org/10.2217/fmb.15.48
Ganeev RA, Baba M, Ryasnyansky Al, Suzuki M, Kuroda H.
Characterization of optical and nonlinear optical
properties of silver nanoparticles prepared by laser
ablation in various liquids. Opt Commun;240(4-6):437-
Giorgetti E, Muniz Miranda M, Caporali S, Canton P, Marsili
P, Vergari C, et al. 2015. TiO2 nanoparticles obtained by
laser ablation in water: influence of pulse energy and
duration on the crystalline phase. J Alloy
Compd;643(S1):S75-9.
Gondal, M.A., Qahtan, T.F., Dastageer, M.A., Saleh, T.A.,
Maganda, Y.W. and Anjum, D.H., 2013. Effects of
oxidizing medium on the composition, morphology and
optical properties of copper oxide nanoparticles
produced by pulsed laser ablation. Applied surface
science, 286, pp.149-155.
Halbus, A.F., Horozov, T.S. and Paunov, V.N., 2019. Strongly
enhanced antibacterial action of copper oxide
nanoparticles with boronic acid surface
functionality. ACS applied materials & interfaces,11(13),
pp.12232-12243.
Ismail, R.A., Sulaiman, G.M., Mohsin, M.H. and Saadoon,
A.H., 2018. Preparation of silver iodide nanoparticles
using laser ablation in liquid for antibacterial
applications. IET nanobiotechnology,12(6), pp.781-786.
Kareem, M.M., 2021. The Effect of Laser Shots on
Morphological and Optical Properties of Copper Oxide
NPs Prepared by Nd-Yag Laser of 1064 nm
Wavelengths in Distilled Water. Passer Journal of Basic
and Applied Sciences, 3(2), pp.200-206.
Mafune, F., Kohno, J.Y., Takeda, Y., Kondow, T. and
Sawabe, H., 2001. Formation of gold nanoparticles by
laser ablation in aqueous solution of surfactant. The
Journal of Physical Chemistry B,105(22), pp.5114-5120.
Menazea, A. A., Elashmawi, I. S., El-kader, F. A., Hakeem, N.
A., 2018. Nanosecond pulsed laser ablation in liquids as
new route for preparing polyvinyl carbazole/silver
nanoparticles composite: spectroscopic and thermal
studies. J Inorg Organomet Polym . 28, 2564-2571.
https://doi.org/10.1007/s10904-018-0890-z.
Monteiro, D.R., Gorup, L.F., Takamiya, A.S., Ruvollo-Filho,
A.C., de Camargo, E.R. and Barbosa, D.B., 2009. The
growing importance of materials that prevent microbial
adhesion: antimicrobial effect of medical devices
containing silver. International journal of antimicrobial
agents, 34(2), pp.103-110.
Nie, S., Emory,S. R.,1997. Probing Single Molecules and
Single Nanoparticles by Surface-Enhanced Raman
Scattering .Science. 275, 1102-1106.
DOI: 1O.1126/science.275.53O3.11O2
Niu, K.Y., Yang, J., Kulinich, S.A., Sun, J., Li, H. and Du, X.W.,
Morphology control of nanostructures via surface
reaction of metal nanodroplets. Journal of the
American Chemical Society,132(28), pp.9814-9819.
Pena C, Suarez C, Tubau F, Dominguez A, Sora M, Pujol M,
Gudiol F, Ariza J. 2009. Carbapenem-resistant
Pseudomonas aeruginosa: factors influencing
multidrug-resistant acquisition in non-critically ill
patients. Eur J Clin Microbiol Infect Dis.28(5):519-22.
http://dx.doi.orq/10.1007/s10096-008-0645-9
Patra N, Akash K, Shiva S, Gagrani R, Rao HSP, Anirudh VR,
et al. 2016. Parametric investigations on the influence of
nano-second Nd 3+ :YAG laser wavelength and fluence
in synthesizing NiTi nano-particles using liquid assisted
laser ablation technique. Appl Surf Sci,*366:104-11.
Shirsat, S., Pawar, D.N., Jain, N., Pawar, J., Tale, V.S., &
Henry, R.
Synthesis of copper oxide nanoparticles by chemical
precipitation method for the determination of
antibacterial efficacy against Streptococcus sp. and
Staphylococcus sp. Asian Journal of Pharmaceutical
and Clinical Research,135-138.
Taue, J., Grigorvici , R., Vancu , A.,1966. Optical properties
and Electronic structure of Amorphous Germanium .
Phys. Status solid B ,15, 627-637. DOI:
O.1OO2/pssb.1966O156224.
Triloki., Rai, R., Singh, B.K., 2013. Absorbance and
Transmittance measurement of Csl thin films,
Proceedings of the DAE Symp. on Nucl. Phys. 58, 838-
Yang .G. 2012.Laser ablation in liquids: principles and
applications in the preparation of nanomaterials. CRC
Press, p. 1192.
Zeng, H„ Cai, W., Li, Y., Hu, J. and Liu, P., 2005.
Composition/structural evolution and optical properties
of ZnO/Zn nanoparticles by laser ablation in liquid
media. The Journal of Physical Chemistry B,109(39),
pp.18260-18266.
Zeng, H., Xu, X., Bando, Y., Gautam, U.K., Zhai, T., Fang, X.,
Liu, B. and Golberg, D., 2009. Template Deformation
Tailored ZnO Nanorod/Nanowire Arrays: Full Growth Control and Optimization of Field Emission. Advanced
Functional Materials,19(19), pp.3165-3172.
Zhang, Q., Zhang, K., Xu, D., Yang, G., Huang, H., Nie, F., Liu,
C. and Yang, S., 2014. CuO nanostructures: synthesis,
characterization, growth mechanisms, fundamental
properties, and applications. Progress in Materials
Science, 60, pp.208-337.
Zoolfakar, A.S., Rani, R.A., Morfa, A.J., O'Mullane, A.P. and
Kalantar-Zadeh, K., 2014. Nanostructured copper oxide semiconductors: a perspective on materials, synthesis methods and applications, journal of materials chemistry c, 2(27), pp.5247-5270.
Downloads
Published
Issue
Section
License
You are free to:
- Share — copy and redistribute the material in any medium or format for any purpose, even commercially.
- Adapt — remix, transform, and build upon the material for any purpose, even commercially.
- The licensor cannot revoke these freedoms as long as you follow the license terms.
Under the following terms:
- Attribution — You must give appropriate credit , provide a link to the license, and indicate if changes were made . You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
- No additional restrictions — You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits.
Notices:
You do not have to comply with the license for elements of the material in the public domain or where your use is permitted by an applicable exception or limitation .
No warranties are given. The license may not give you all of the permissions necessary for your intended use. For example, other rights such as publicity, privacy, or moral rights may limit how you use the material.
